maximum torque造句
例句与造句
- Speed at maximum torque
最大扭矩转速 - Maximum torque control for field weakening operation of asynchronous motor applied in electric vehicle
电动汽车用异步电机弱磁运行的最大转矩控制 - Maximum torque per ampere control in permanent magnet synchronous motor direct torque control driving system
电动汽车用永磁同步电动机直接转矩控制系统 - With reversible motors that are rated for continuous duty , nibco electric actuators provide maximum torque output and longer life
配置可逆电机，适用于连续工作，美国尼伯科电动执行机构能够提供最大的扭矩输出和更长的使用寿命。 - Static torque : a fixed location under the maximum torque can be applied to the output shaft . if the torque exerted greater than this value will be separated for damage
静态扭矩：在固定位置下最大扭矩可施加到出力轴上。如果施加的扭矩大于这个数值，则会损坏分割器。 - It's difficult to find maximum torque in a sentence. 用maximum torque造句挺难的
- In this paper , the maximum torque per ample ( mtpa ) control in permanent magnet synchronous motor ( pmsm ) direct torque control ( dtc ) driving system was studied
摘要在永磁同步电动机直接转矩控制和最大转矩电流比控制理论基础上，研究了永磁同步电动机直接转矩控制驱动系统最大转矩电流比控制的实现。 - Based on artificial neutral network control theory , a mimo neutral network pid speed regulator realizing the maximum torque with minimum current is conformed for a pmsm drive system
本论文在人工神经网络控制理论的基础上，针对永磁同步电动机矢量控制系统，构造实现最大转矩电流控制的mimo神经网络pid速度控制器。 - By adjusting the fuel rectifying screw and then increasing the fuel quantity per cycle , the loss of the maximum power of e30 engine ca n ' t exceed 10 % of the maximum power of diesel , and the loss of the maximum torque can be controlled within 2 percent
通过旋出油量校正螺钉，增大燃料供给量，可以使e30混合燃料发动机的最大功率损失控制在10以内，最大转矩损失控制在2以内。 - The instantaneous torque measurement system has been improved , which uses slip ring to transmit signal , improved measuring accuracy and stability , the mechanism of occurring of instantaneous maximum torque has been understood during changeover of the main engine
改进了集流环传输信号的瞬时扭矩测量系统，提高了测量精度和稳定性，进一步认清了在主机切换过程中瞬时扭矩的极大值产生的机理。 - And it analyses the power factor in different conditions via the fourier anlysis of the stator current and voltage . then , it sets up the simulating model for maximum torque / current ratio . the torque can be controlled by controlling the angle of stator current vector
在矢量控制实现的基础上,采用傅立叶分解分析电机的相电流和相电压,得到矢量控制系统中电压和电流的基波分量和相位角,进而判断电机的功率因数,分析在不同控制情况下电机的功率因数状况。 - According to the relationship of the angle of the maximum torque and the q axis , the reluctance torque for salient pmsm is made full use of and the sator current amplitude is reduced by a large percentage , so that the system robustness is greatly increased . at the speed loop , this paper presents a single value model algorithmic control strategy which is the simplied form of normal model algorithmic control and has less computation work than the latter , so the real - time performance is very good
对于嵌入式pmsm ，根据在电流幅值一定的条件下最大输出转矩与(为等效电流矢量和q轴之间的相位角)之间的关系，将磁阻转矩转换为输出转矩从而提高了输出转矩，改善了系统的控制性能；在速度环采用单步模型算法控制，其计算量比较少，提高了系统的实时性和鲁棒性。 - Based on the torque - speed characteristic curve of induction motors , analyses were done on changes in slip with an variation in frequency when an induction motor drives different kinds of loads , including those with constant torque , constant - maximum torque , variable torque ( except fans and pumps ) and constant power , as well as fans and pumps , the formulas to calculate the slip and the speed under different frequencies and loads were presented
摘要以异步电动机机械特性曲线为基础，分析了变频调速异步电动机在拖动恒转矩负载、恒最大转矩负载、变转矩（非风机和泵类）负载、恒功率负载以及风机和泵类负载时，转差率随频率变化的规律。